To implement transient learning using ION Setup:
1. Start ION Setup.
2. Open the Setup Assistant for your meter.
3. Click Alarming > Transient.
4. Select Transient/Waveshape and click Learn.
The Global Setpoint Learning screen is displayed.
5. Click Setup.
The Alarm Learning Setup screen is displayed.
6. Configure the transient threshold learning parameters and click Save.
7. Click Start to begin transient learning.
Learning status and time remaining are indicated in the Learning Status box.
Click Abort to stop transient learning.
8. Apply the learned values.
Automatic: the threshold is automatically applied unless there are issues with the
learning process.
Manual: Click Alarming > Transient. Select Transient/Waveshape and click Learn.
Click Install to apply the learned values.
NOTE: While learning is in progress (in either manual or automatic installation mode), it
stops the learning process and prompts you for confirmation that you want to stop learning
and install the learned limits. Once you have confirmed, the learned values are
automatically installed or prepared for manual installation.
Parameter Value/Range Description
Install mode
Automatic,
Manual
Automatic: the learned values are automatically
applied.
Manual: the learned values are stored for you to
review and enter.
Duration 1–365 Days for maximum learning duration.
Transient learning parameters
9810 series - User manual Alarms and alerts
7EN05-0390-08 194
To Next Page
Loading...
