SIGLENT SDS2000X - To Set Display Type

SIGLENT
144 SDS2000X User Manual
To Set Display Type
Press the Display button on the front panel, and then press the Type softkey to select
Vectors or Dots display type.
 Vectors: the sample points are connected by lines and displayed. Normally, this
mode can provide the most vivid waveform to view the steep edge of the waveform
(such as square waveform).
 Dots: display the sample points directly. You can directly view each sample point and
use the cursor to measure the X and Y values of the sample point.
Figure 81: Vectors Display
Figure 82: Dots Display