EtherHaul Operation, Administration and Maintenance Manual
Page 103
This section allows configuring the following parameters:
Role – the EtherHaul radio on one side of the link should be “master” while the
other should be “slave”.
Backup Port – the Ethernet port in the EtherHaul to which the sub-6 GHz radio is
connected to. (Default: Eth2)
VID – VLAN id used for the backup signaling (G.8032). (Default: 1)
Capacity Threshold [Mbps] – the capacity for which below it the traffic is routed
to the sub-6 GHz link. (Default: 80 Mbps).
Main Path – status of the EtherHaul main path link.
Backup Path – status of the sub-6 GHz backup path link.
As the ExtendMM soultiuon is based on the ITU-T G.8032 Ethernet Ring Protection
Switching standard, refer to the Ethernet Ring Protection (ERP) section of this
document for in-depth description of the protection mechanism.
To Next Page
Loading...
