EtherHaul Operation, Administration and Maintenance Manual
Page 43
6.3.4 Scripts
Figure 6-6 System Page: Maintenance – Scripts
The EtherHaul supports the use of pre-composed, multiple-line command scripts.
A script is simply a list of CLI commands, saved as a text file that runs locally on the
system. Script output is displayed on a script output screen and can be copied and
saved.
The Scripts section displays the scripts that were loaded to the system.
There are useful scripts that are pre-loaded to the system in the factory:
1) clear_statistics – this scripts clears all the statistics counters of the system,
including RF statistics, Ethernet statistics, VLAN statistics and Queue
statistics.
2) System_info – this script collects all the relevant system status, logs,
configurations and statistics.
3) Restore_networking_config – restore all Ethernet networking configuration
(VLANs) to default. Refer to the Ethernet Services Configuration and
Monitoring chapter for description.
4) Restore_qos_config – restore all Quality of Service configuration to default.
Refer to the Quality of Service chapter for description.
For EH-1200F/FX and EH-600T systems, additional scripts are available:
5) Bridge_mode_customer-nni – change bridge configuration. Refer to the
Ethernet Services Configuration and Monitoring chapter for description.
6) bridge_mode_customer-uni – change bridge configuration. Refer to the
Ethernet Services Configuration and Monitoring chapter for description.
To Next Page
Loading...
