Siklu EtherHaul - CLI Commands; Snmpv3 Users Configuration

EtherHaul Operation, Administration and Maintenance Manual
Page 131
14.2 CLI Commands
 Users:
Viewing users list:
show user
 Tacacs:
Viewing authentication:
show aaa
Configuring Tacacs authentication:
set aaa mode tacacs shared-secret 123456
Viewing servers:
show aaa-server
Configuring Tacacs server:
set aaa-server 1 ip-addr 192.168.0.22 port 49 accounting-port ssh
Sending Dummy Authentication request:
set aaa-server 1 send-dummy-auth username dummy1 password pass1
Viewing Dummy Authentication status:
show aaa-server
 Radius:
Viewing authentication:
show aaa
Configuring Radius authentication:
set aaa mode radius shared-secret 123456
Viewing servers:
show aaa-server
Configuring Tacacs server:
set aaa-server 1 ip-addr 192.168.0.22 port 1812 accounting-port ssh
14.3 SNMPv3 Users Configuration
Note:
SNMPv3 Users configuration supported in the CLI only.