EtherHaul Operation, Administration and Maintenance Manual
Page 26
3.4 Quick Configuration Wizard
Use the Quick Configuration wizard to configure the basic system parameters for both
local and remote systems. It holds the basic minimal configuration required to start
using the link.
The Quick Configuration wizard should be used for the initial system setup after
installation. For monitoring and advanced configuration, please refer to the dedicated
configuration pages of the Web-Based Management.
The Quick Configuration wizard is described in the individual product’s Installation
Manual.
3.5 General Configuration Commands
3.5.1 Apply
Any configuration change is executed upon clicking Apply.
The Local-Remote concept of the Web-Based Management allows configuring both local
and remote systems of the link.
The Apply button is available at the bottom of each configuration page (one button for
both local and remote systems).
When clicking Apply, the configuration changes will be sent to remote system first and
then to the local system. If multiple parameters changed on the page before clicking
Apply, all parameters are sent in bulk to the system and then executed locally in order
to avoid losing management connection.
3.5.2 Save Configuration
Any configuration change applied should be saved using the Save Configuration
button.
The system has two configuration banks:
1. Running Configuration – the currently active configuration. Every time Apply is
clicked, the Running Configuration is updated.
2. Startup Configuration – the configuration the system will come up with after the
next reset. This configuration may be different than the currently active
configuration (Running Configuration).
In order to save the applied configuration changes, click Save Configuration so
changes will be saved to the startup configuration. If changes are not saved to the
startup configuration, they will be lost the next time the system resets.
Save Configuration buttons are available for local and remote systems.
To Next Page
Loading...
