EtherHaul Operation, Administration and Maintenance Manual
Page 46
6.4 Event Configuration
Figure 6-9 Network Page: Event Configuration
The EtherHaul supports masking of individual/group alarms and events. In case alarm is
masked, it is not displayed in the Active Alarms and Event Log and no trap is sent.
By default, none of the alarms are masked but the RSSI, CINR and Lowest
Modulation threshold-crossing alarms. In addition, some alarms have configurable
thresholds to raise and clear alarm.
This section allows configuring the following parameters:
Event – the event/group of events to be configured
Trap – checkbox to enable sending SNMP trap for this event.
Alarm – checkbox to enable raising an alarm for this event (meaning, showing it
in the active Alarms list and in the log file). Note that not all events can be
configured as Alarms.
Threshold – the following events have configurable thresholds for alarm
raise/clear and for sending traps. The threshold hysteresis can be defined (to
avoid toggling alarms).
To Next Page
Loading...
