EtherHaul Operation, Administration and Maintenance Manual
Page 113
show cfm-ma {<md-idx-list> | all} {<ma-idx-list> | all} {name |
component | interval | info}
Use the following command to clear a particular MA or all MAs:
clear cfm-ma {<md-idx-list> | all} {<ma-idx-list> | all}
13.1.4 Working with Component Maintenance Associations
Use the following command to set a Component MA:
set cfm-ma-comp <comp-id> <md-idx> <ma-idx> [vlan <vid>] [mhf-
creation <mhf-creation>] [mhfid-permission <mhf-permission>]
Use the following command to display a particular Component MA or all Component
MAs:
show cfm-ma-comp {<comp-id-list | all} {<md-idx-list> | all} {<ma-
idx-list> | all} {vlan | mhf-creation | mhfid-permission | info}
Use the following command to clear a particular Component MA or all Component MAs:
clear cfm-ma-comp {<comp-id-list | all} {<md-idx-list> | all}
{<ma-idx-list> | all}
13.1.5 Working with Maintenance End Points (MEPS)
A Maintenance End Point (MEP) is a point, on the perimeter of a domain, which sends
and receives CFM frames through the domain.
Use the following command to set an MEP:
set cfm-mep <md-idx> <ma-idx> <mepid> [interface <ext-bridge-port-
list>] [dir {down | up}] [vlan {1..4094}] [admin-state {active |
inactive}] [cci {enabled | disabled}] [msg-prio {0..7}] [low-
defect <low-defect>] [alarm-time {250..1000}] [reset-time
{250..1000}] [lbm-dst-type {mac | mepid}] [lbm-dst-mac <mac addr>]
[lbm-dst-mepid <mepid>] [lbm-tx-num {1..1024}] [lbm-tx-data <hex
string>] [lbm-tx-prio {0..7}] [lbm-tx-drop {enable | disable}]
[ltm-dst-type {mac | mepid}] [ltm-dst-mac <mac addr>] [ltm-dst-
mepid <mepid>] [ltm-tx-ttl {0..250}] }] [lbm-tx-status {tx-
pending | tx-idle}] [ltm-tx-status {tx-pending | tx-idle}]
Use the following command to display a particular MEP or all MEPs:
show cfm-mep [{<md-idx-list> | all} [{<ma-idx-list> | all}
[{<mepid-list> | all}]]] {interface | dir | vlan | admin-state |
cci | msg-prio | low-defect | alarm-time | reset-time | lbm-dst-
mac | lbm-dst-mepid | lbm-dst-type | lbm-tx-num | lbm-tx-data |
lbm-tx-prio | lbm-tx-drop | ltm-dst-mac | ltm-dst-mepid | ltm-
dst-type | ltm-tx-ttl | lbm-tx-status | ltm-tx-status | fng-state
| mac | high-defect | defects | ccm-seq-errors | ccm-tx | lbm-tx-
To Next Page
Loading...
