Siklu EtherHaul - Working with CCM Messages

EtherHaul Operation, Administration and Maintenance Manual
Page 115
13.1.7 Working with CCM Messages
An MEP can periodically transmit a multicast Connectivity Check Message (CCM)
announcing the identity of the MEP and its MA. The MEP also tracks CCMs received
from the other MEPs.
The following information is displayed per CCM message stored:
 Eth Source Address
 VLAN Priority (PCP)
 Drop Eligibility
 VLAN ID
 MD Level
 Version
 RDI
 CCM Interval
 Sequence Number
 Counters: TxFCf, RxFCb, TxFCb
 If present:
 Sender Chassis Subtype and ID
 Management Address Domain
 Management Address
 Port Status -- {blocked | up} (according to IEEE 802.1ag Table 21-10)
 Interface Status -- {up | down | testing | unknown | dormant | not-present
| lower-layer-down} (according to IEEE 802.1ag Table 21-1)
 Other TLVs: Type, Data as hexadecimal string
To display this information, use the following commands:
show cfm-ccm [{<md-idx-list> | all} [{<ma-idx-list> | all}
[{<mepid-list> | all}]]] last-error-ccm
and
show cfm-ccm [{<md-idx-list> | all} [{<ma-idx-list> | all}
[{<mepid-list> | all}]]] last-xcon-ccm