EtherHaul Operation, Administration and Maintenance Manual
Page 57
Chassis ID – displays the IP address (network address, typically refer to IP #1) of
remote device
Chassis ID Subtype – will be 'network-addr'
Port ID – displays the received MAC address
Port ID Subtype – will be 'mac-addr'
Port Description – The port connected at the peer device
System Name – of peer device
System Description – of peer device
Mng. Address – IP address that peer device reports. As there can be multiple IP
addresses, the device reports the IP address according to LLDP
Configuration: IP Index configured above.
7.6 CLI Commands
IP Addresses (IPv4):
show ip
Setting IP address (static IP example):
set ip 2 ip-addr static 10.10.10.1 prefix-len 23 vlan 12
Setting IP address (DHCP example):
set ip 2 ip-addr dhcp
Deleting IP address:
clear ip 2
IPv6 IP Addresses:
Viewing IPv6 addresses:
show ipv6
Setting IPv6 IP address (static IP example):
set ipv6 2 ipv6-addr static 0001:0001:0001:0001:0001:0001:0001:0001
prefix-len 32 vlan 200
Deleting IPv6 address:
clear ipv6 2
Default Gateway and Static Routes:
Viewing default gateway and routes (IPv4):
show route
Viewing default gateway and routes (IPv6):
show route6
Setting default gateway and routes (IPv4):
set route 1 dest 0.0.0.0 prefix-len 0 next-hop 82.166.81.138
Setting default gateway and routes (IPv6):
To Next Page
Loading...
