Siklu EtherHaul - Bridge VLAN Ethertype; Default C-VLAN Ethertype

EtherHaul Operation, Administration and Maintenance Manual
Page 73
The system maintains 64 permanent instances of the FDB object that can be created on
S1 (separate instances based on S-VLANs only).
By default, FDB #1 is used for all incoming packets.
The default aging time for all FDBs is 172800 seconds (48 hours).
Creating and modifying FDB aging:
set fdb <component-id> <fdb-id> [aging <value>]
<component-id> : s1
<fdb-id> : set of 1..64
<aging value> : 5..1000000
Creating and modifying entries in the FDB Address table:
set fdb-table <component-id> <fdb-id-list> <mac-addr> bridge-port
<value> [quota <value>]
<component-id> : c1 | c2 | c3 | c4 | c5 | c6 | s1
<fdb-id-list> : list: | integer 1..64
<mac-addr> : mac
Clearing FDB table:
clear fdb-table all all all
8.6.5 Default C-VLAN EtherType
By default the C-VLAN EtherType is 0x8100.
That means that unless specifically configured for a specific bridge, the C -VLAN
EtherType will be set to 0x8100.
You can change the default EtherType using the CLI.
set bridge-common def-cvlan-etype
hex number 0x700..0xFFFF except 0x800, 0x806, 0x8809, 0x88CC, 0x8902
8.6.6 Bridge VLAN EtherType
By default the S-VLAN EtherType is 0x88a8 and the C-VLAN EtherType is 0x8100 (as the
Default C-VLAN EtherType).
You can change the default EtherType using the CLI.
set bridge-common def-cvlan-etype
hex number 0x700..0xFFFF except 0x800, 0x806, 0x8809, 0x88CC, 0x8902
set bridge <component-id> [vlan-ethertype <value>]
<component-id> : c1 | c2 | c3 | c4 | c5 | c6 | s1
<vlan-ethertype value> : hex number 0x700..0xFFFF except 0x800, 0x806,
0x8809, 0x88CC, 0x8902, 0x86DD