Siklu EtherHaul - Page 118

EtherHaul Operation, Administration and Maintenance Manual
Page 118
set cfm-ma-comp c2 1 1 vlan 200
The following command creates a Maintenance End Point (MEP):
set cfm-mep 1 1 2 interface eth0 dir down cci enabled
The following command creates a Peer MEP:
set cfm-peer-mep-create 1 1 1
The following command creates an MD at level 2:
set cfm-md 2 name string Customer level 2
The following command creates an MA:
set cfm-ma 2 2 name string Customer interval 1s
The following command creates a Component MA and assigns VLAN 200 as its Service
Selector:
set cfm-ma-comp c3 2 2 vlan 200
The following command creates a Maintenance End Point (MEP):
set cfm-mep 2 2 2 interface eth1 dir up cci enabled
The following command creates a Peer MEP/;
set cfm-peer-mep-create 2 2 1
The following command sets the MIP to the lower level:
set cfm-ma-comp c3 2 2 vlan 200 mhf-creation explicit
Checking the CCM Status
show cfm-peer-mep
cfm-peer-mep 1 1 1 2 state : ok
<---ok or failed
cfm-peer-mep 1 1 1 2 failed-ok-time : 0000:02:22:05
cfm-peer-mep 1 1 1 2 mac : 00:24:a4:00:01:e1
cfm-peer-mep 1 1 1 2 rdi : off
cfm-peer-mep 1 1 1 2 port-status : unknown
cfm-peer-mep 1 1 1 2 if-status : unknown
cfm-peer-mep 1 1 1 2 chassis-id-subtype : unknown
cfm-peer-mep 1 1 1 2 mng-addr-domain : unknown
cfm-peer-mep 2 2 1 2 state : ok
cfm-peer-mep 2 2 1 2 failed-ok-time : 0000:02:22:05
cfm-peer-mep 2 2 1 2 mac : 00:24:a4:00:01:e2
cfm-peer-mep 2 2 1 2 rdi : off
cfm-peer-mep 2 2 1 2 port-status : unknown
cfm-peer-mep 2 2 1 2 if-status : unknown
cfm-peer-mep 2 2 1 2 chassis-id-subtype : unknown