EtherHaul Operation, Administration and Maintenance Manual
Page 121
cfm-mep 2 2 1 ltm-tx-ttl : 64
cfm-mep 2 2 1 lbm-tx-status : tx-idle
cfm-mep 2 2 1 ltm-tx-status : tx-idle
cfm-mep 2 2 1 fng-state : fngReset
cfm-mep 2 2 1 mac : 00:24:a4:00:07:5a
cfm-mep 2 2 1 high-defect : none
cfm-mep 2 2 1 defects :
cfm-mep 2 2 1 ccm-seq-errors : 2
cfm-mep 2 2 1 ccm-tx : 1948
cfm-mep 2 2 1 lbm-tx-result : ok
cfm-mep 2 2 1 lbm-tx-sn : 9
cfm-mep 2 2 1 lbm-next-sn : 10
cfm-mep 2 2 1 lbr-in-order : 10
cfm-mep 2 2 1 lbr-out-of-order : 0
cfm-mep 2 2 1 lbr-tx : 0
cfm-mep 2 2 1 ltm-next-sn : 0
cfm-mep 2 2 1 ltr-unexpected : 0
cfm-mep 2 2 1 ltm-tx-result : unknown
cfm-mep 2 2 1 ltm-tx-sn : 0
cfm-mep 2 2 1 lm : disabled
cfm-mep 2 2 1 lm-interval : 10s
cfm-mep 2 2 1 dm : disabled
cfm-mep 2 2 1 dm-interval : 10s
cfm-mep 2 2 1 ais-generate : disabled
cfm-mep 2 2 1 ais-period : 1s
cfm-mep 2 2 1 ais-level : 7
cfm-mep 2 2 1 ais-suppress : enabled
cfm-mep 2 2 1 ais-defects : none
Configuring the Link Trace
There are five indices. The first three are the MEP, the fourth is the index number of the
LTR packet (each LTR is one packet), and the fifth is the number of replies according to
their order of arrival. Where several elements answer, you must check the TTL to
identify the trace.
Enter the following on the link level:
set cfm-mep 1 1 1 ltm-dst-type mepid
set cfm-mep 1 1 1 ltm-dst-mepid 2
set cfm-mep 1 1 1 ltm-tx-status tx-pending
show cfm-mep 1 1 1 ltr
cfm-mep 1 1 1 0 0 rx-ttl : 63
cfm-mep 1 1 1 0 0 ltr-forward : unknown
cfm-mep 1 1 1 0 0 relay-action : hit
cfm-mep 1 1 1 0 0 chassis-id-subtype : unknown
To Next Page
Loading...
