EtherHaul Operation, Administration and Maintenance Manual
Page 129
Only admin user is defined in the system. All other users (including their name,
password and type) are defined in the server.
This section allows configuring the following parameters:
Authentication Mode – Tacacs.
Shared Secret – In Radius or Tacacs mode, Shared Secret should be entered
(identical to the one in the server). Note that is using more than one AAA server,
the servers should have the same Shared Secret.
# - Server index. Up to 5 servers can be configured. The Authentication starts
from the 1st server and goes down to the 5th.
IP Address – of the AAA server.
Protocol Port – the default port for Tacacs is 49.
Accounting Port – none, SSH, HTTP, all.
Dummy Authentication is used for sanity check (connectivity test) to the AAA server.
If the AAA server has Dummy user define, select the Server Index and enter the
username and password. After clicking Send Dummy Auth, you will be able to see the
reply status in the Dummy Auth Status field.
Dummy Authentication is supported for Tacacs only.
To Next Page
Loading...
