Siklu EtherHaul - Page 59

EtherHaul Operation, Administration and Maintenance Manual
Page 59
Setting password strength:
set password-strength min-length 8 min-difference 0
 Syslog Server:
Viewing servers:
show syslog
Configuring server:
set syslog 2 server 192.168.0.222
Deleting user:
clear syslog all
 Connectivity:
Ping:
ping 192.168.0.222
ping configuration options:
ping [-c <num-packets 1..32000>] [-t] [-l <packet-length 0..5000>] <host>
-t - ping until stopped by ctrl/c
Trace Route:
tracert 192.168.0.222
tracert configuration options:
tracert [-h <maximum-hops 1..255>] [-w <timeout, sec, 1..86400>] <host>
Ping (IPv6):
Ping6 0001:0001:0001:0001:0001:0001:0001:0002
Trace Route (IPv6):
Tracert6 0001:0001:0001:0001:0001:0001:0001:0002
 ARP Table (Address Translation):
Viewing ARP Table:
show arp
Configuring entries in the ARP table:
Set arp 192.168.0.222 mac-addr 01:02:03:04:05:06
Deleting entries:
clear arp 192.168.0.222
 LLDP:
Viewing LLDP configuration:
show lldp
Configuring LLDP:
set lldp eth1 admin rx-tx vid 500 ip-index lowest
Viewing LLDP status:
show lldp-remote