Silca UC 199 - Page 35

Reading & cutting
in progress
ATTENTION: The key depth is not fully cut during reading.
CUTTING IN PROGRESS
Copy: 1 of: 10
Press CLEAR to
stop the cycle…
When CLEAR is pressed (for about 2 seconds) the cycle is stopped. The cut being made will be
completed and then the carriages will stop in their initial position and the following screen will appear:
Stopping cycle
In progress …
Feeder ready
Adapter:
Pcs.: 2 / 10 [START]
Themachinewillcontinueuntiltheprogrammedoperationisnished.Thedisplaywillshow:
Copy: 10 of: 10
Finished.
Morecopies?
No=STOP Yes=ENTER
Press ENTER to repeat the cycle and copy more keys.
Press STOP:
Original on right
Feeder ready
Adapter:
Pcs: 1 / 1 [START]
Press STOP to return to the main menu.
ATTENTION: if a machining cycle is interrupted (intentionally or accidentally), the display
will show:
ATTENTION
Remove key from
clamp!
[START]
IT IS COMPULSORY to remove the key:
press START, raise the safety shield and remove the key from the Automatic Clamp.
The display will show the message:
Zero the axes !
[START]
Operating Manual UC199
Copyright Silca 2012
31