Silca UC 199 - Page 41

Fig. 48
ATTENTION: if the absence of key blanks in the loader is detected during the cycle, the
display will show:
FEEDER EMPTY
Pieces maked: x / y
Continue?
No=STOP Yes=START
Open the guard and insert one or more key BLANKS (according to needs). At the cutting stage it can be used to
knowhowmanykeysshouldbeaddedtonishthejob.
NOTE: press SHIFT + START to continue, even if the key has not been detected (e.g. head bore too
big).
Operating Manual UC199
Copyright Silca 2012
37