• Range markers
• Compass
• Heading line
• Active route
Radar panel symbology can be collectively turned on/off from the
Symbology option in the More sub-menu if they are selected to
show in the radar settings dialog.
Bearings
Used for selecting whether the bearing should be measured in
relation to True/Magnetic North (°T/°M), or relative to own vessel
(°R).
Ú
Note: True bearing can only be selected when a compass is
available.
Data bar
Turns on/off the radar data bar. Refer to the radar panel illustration.
By default, the data shows targets arranged with the most
dangerous targets on top. You can select to show radar targets on
top and before any AIS targets, even if the AIS targets are
considered more dangerous.
Vessels and tracked targets
This dialog contains settings for both AIS and radar targets. AIS
specific settings are only available if you have a capable AIS device
connected to your system.
Use this option to specify:
134
Radar | GO XSE/XSR Operator Manual
To Next Page
Loading...
Need help?
General
