• Dangerous targets
- Time to closest point of approach - specify the time of
approach in which a vessel is to be considered dangerous.
- Closest point of approach - specify the closest point of
approach in which a vessel is to be considered dangerous. This
setting determines the size of the safe ring if safe ring is
enabled, refer to "Safe ring" on page 135.
• Targets of interest - targets further away than the following
distance will be hidden:
- Range of interest - specify to show targets in all ranges
(based on radar range) or targets within a specific distance of
own vessel.
• Filtering - define which and how many AIS targets will be shown.
If the amount of targets exceeds the set number, only the most
interesting targets will be shown. For radars that support tracking
targets, the following target filter settings will also apply to
tracked targets.
Filter options are:
- Show - specify to show all targets, dangerous targets, or no
targets.
- Max AIS targets - specify to show all AIS targets or specify a
maximum number of AIS targets to be shown.
- Hide slower than - specify to hide targets slower than a
specific speed or all targets regardless of speed.
- Hide lost targets after – specify to hide targets that are lost
after a certain amount of time or do not hide any lost targets.
Safe ring
A safe ring can be added around your vessel to present the danger
zone. The radius of the ring is the same as the closest point of
approach as set in the Vessels and Tracked Targets dialog. Refer to
"Vessels and tracked targets" on page 134.
Installation
The Installation option is used for making radar installation settings.
Installation settings must be made before using the radar.
Installation setup settings are described in the separate Radar or the
display unit's installation manuals.
Radar | GO XSE/XSR Operator Manual
135
To Next Page
Loading...
Need help?
General
