From within this dialog you can select and configure the active GPS
sensor.
PIN code
Sets a PIN code to prevent unauthorized access to your system's
settings.
Ú
Note: Record the PIN code and store it in a safe place.
When you establish password protection, the PIN code must be
entered when any of the following are selected. After the correct
PIN code is entered, all of them can be accessed without re-entering
the PIN code.
• Settings, activated from the home page or system controls
dialog.
• Alarms, activated from the toolbar.
• Storage, activated from the toolbar.
• Store, activated from the toolbar.
Restore defaults
Restores selected settings to default factory values.
Ú
Note: If waypoints, routes, or tracks and trips are selected, they
are permanently deleted.
Tools and settings | GO XSE/XSR Operator Manual
215
To Next Page
Loading...
