Installation
20169223D 5-39
INFO loop II
To access this level, keep the INFO button pressed while pressing
and releasing the WEATHER button and thereafter the INFO button.
Note ! The settings in INFO-loop II are intended to be used to adapt the control
logic of AP9 MK3 to the characteristics of the particular vessel on which it
is installed. After satisfactory steering performance is reached during sea
trials, these settings should not be altered. Remember to store according to
SAVE IDEAL on page 5-46.
Return to LANGUAGE
* To enter the loop, press INFO + WEATHER,
release WEATHER, release INFO.
* Advance one step at the time by
pressing INFO.
* Use INCREASE/DECREASE
to set parameters.
LANGUAGE
SPEED SENS
DEADBAND
SERV. SP
MIN. RADIUS
FU/A SCALE
NAV. MODE
NMEA 1/5 SEC.
MIN THRUST.
THRUST. D.B.
THRUSTER FUNC
CTS
PRIORITY
XTE
ONLY THRUSTER
RUDDER+THRUST
ONLY RUDDER
Only when "THRUSTER"
configuration is selected
*
*
MIN. RUDD.
SW / RUNTIME
MAX RUDD LIM
ECDIS
1/SEC OUT FREQ
5/SEC OUT FREQ
FLUXGATE OFFSET
Fig. 5-40 Info loop 2
To Next Page
Loading...
