Robertson AP9 MK3 Autopilot
2-30 20169223D
WRONG DATAFORMAT
CHECK NAVSETTING
This fault alarm indicates wrong data format.
WATCH ALARM
PRESS RESET
This warning will occur every four minute when a Watch Alarm unit
is connected (Not supplied by Simrad Robertson any longer).
If the watch alarm should occur when a Watch Alarm Unit is not
connected, use the following procedure to cancel the alarm:
• Enter INFO loop 2 (Press INFO and keep pressed, press
WEATHER, release WEATHER, release INFO)
• Step through the INFO loop 2 by pressing INFO until
SOFTWARE/RUNTIME is reached.
• Press DECREASE appr. 15 times and verify that days/hours
changes to 0 (zero).
• This will then have cancelled the Watch Alarm
For further information refer to paragraph 6.1 Fault warnings.
To Next Page
Loading...
