Operation
25
850--164186 A
3 OPERATION
3.1 Introduction
All operation of the sonar is normally made from the Sonar
Operating Panel. This section contains a detailed description of
the start/stop procedures, the Operating Panel and the menu
operation. In order to get the necessary understanding of the
sonar working principle, read first through the section “System
Description”.
In addition to the Sonar Operating Panel, it is possible to connect
a standard USB mouse or roller-ball with three switches. In such
case, all the sonar operation can be made via the menu system.
Note that the SP70 transducer in its lower position reaches 1,2
meter below the vessel’s hull, and that the maximum specified
speed in that position is 15 knots.
To ensure the best possible reliability of the sonar, it is important
to follow the maintenance procedures described in section
“Maintenance”.
WARNING ! Whenever docking the vessel, the switch S102 at the
rear of the Sonar Processor Unit should be switched to
OFF position to prevent inadvertent use of the sonar.
This, because the transducer can be damaged i f a llowed
transmitting in air.
→ For location of the switch S102, refer to figure 19.
When docking, also refer to section “Maintenance”.
To Next Page
Loading...
Need help?
General
