Ski-Doo ELITE SERIES User Manual

Section 01 SERVICE TOOLS AND SERVICE PRODUCTS
Subsection 01 (SERVICE TOOLS)
Crankshaft bearing puller
(P/N 420 877 635)
2,3
1
2,3
5
4
6,9,10
7,8,11,12
13
1) Screw M16 x 1.5 x 150
(P/N 420 940 755)
2) Screw M8 x 40 (4)
(P/N 420 840 681)
3) Screw M8 x 70 (4)
(P/N 420 841 201)
4) Crankshaft protector PTO
(P/N 420 876 552)
5) Crankshaft protector MAG
(P/N 420 876 557)
6) Puller ring (P/N 420 977 490)
(use with half rings (P/N 420
977 475) or (P/N 420 276
025))
7) Half ring (2) (P/N 420 977 475)
(for 72 mm O.D. bearings)
8) Half ring (2) (P/N 420 276 025)
(for 62 mm O.D. bearings)
9) Puller ring (P/N 420 977 480)
10)Puller ring (P/N 420 977 494)
(for hal rings (P/N 420 977
479))
11)Half ring (2) (P/N 420 977 479)
(for 80 mm O.D. bearings)
12)Half ring (2) (P/N 420 876 330)
(for 52 mm O.D. bearings)
13)Distance ring (P/N 529 035
964) (for MAG side bearing)
APPLICATION
All engines.
N–> Torque flange remover
(P/N 529 035 958)
APPLICATION
1503 engines.
Piston circlip installer
(P/N 529 035 765)
APPLICATION
1004 and 1503 engines.
Piston circlip installer
a. 18 mm (P/N 529 035 561)
b. 20 mm (P/N 529 035 562)
APPLICATION
a. All engines except 593, 693
and 793.
b. 2001 and older 593 and 693
engines.
Piston pin/connecting rod bear-
ing centering tool
(P/N 529 009 100)
NOTE: New diameter is
9.65 mm (.380 in).
APPLICATION
All engines except cageless en-
gines.
Pusher (55/59 mm)
(P/N 529 035 913)
APPLICATION
1004 engines.
Pusher (38/42 mm)
(P/N 529 035 914)
APPLICATION
1004 engines.
Te m pla te 5

Ski-Doo ELITE SERIES Specifications

General

Brand	Ski-Doo
Model	ELITE SERIES
Category	Offroad Vehicle
Language	English