95
SJ6826RT, SJ6832RT
213560ABA
Electrical System Section 4 – Troubleshooting Information
19. Defective Tilt Override/High Drive Cutout switch LS5.
Operate N.C. switch.
Check continuity between wire #10A and wire #35 on
switch when closed.
Replace if defective.
20. Loose or broken wire #35 from Tilt Override/High Drive
Cutout switch LS5 to Elevation/Hi Spd Cutout Relay
35CR.
Check continuity. Replace if defective.
21. Loose or broken wire #02 from Elevation/Hi Spd
Cutout Relay 35CR to Base terminal block TB-1.
Check continuity. Replace if defective.
22. Loose or broken wire #35B from Elevation/Hi Spd
Cutout Relay 35CR to Control Module CM1 pin #P2-
10.
Check continuity. Replace if defective.
23. Loose or broken jumper wire from #28 to # 28A on
outrigger connector CN14 between pin #1 and pin #7.
Check continuity. Replace if defective
24. Loose or broken wire #28A from outrigger connector
CN14 at pin #1 to base terminal block TB-1.
Check continuity. Replace if defective.
25. Outriggers not fully retracted Fully retract outrigger cylinders
26. Loose or broken wire #10A from Base terminal block
TB-1 to Outrigger Control Module OCM1 at pin #P2-
12.
Check continuity. Replace if defective.
27. Left rear outrigger N.O.-held closed limit switch LS64 is
out of adjustment or defective.
Check continuity from wire #10A and wire #64 through
switch when closed.
Adjust switch if out of adjustment.
Replace if defective.
28. Right rear outrigger N.O.-held closed limit switch LS63
is out of adjustment or defective.
Check continuity from wire #64 and wire #63 through
switch when closed.
Adjust switch if out of adjustment.
Replace if defective.
29. Right front outrigger N.O.-held closed limit switch LS62
is out of adjustment or defective.
Check continuity from wire #63 and wire #62 through
switch when closed.
Adjust switch if out of adjustment.
Replace if defective.
30. Left front outrigger N.O.-held closed limit switch LS61
is out of adjustment or defective.
Check continuity from wire #62 and wire #36 through
switch when closed.
Adjust switch if out of adjustment.
Replace if defective.
To order go to Discount-Equipment.com
To Next Page
Loading...
