you that the key is not detected. Start the
vehicle as follows:
1. Press the button of the armrest box
to open the cover
.
2. Place the keyfob in the front of the arm-
rest box.
3. Press the brake pedal, shift to drive
or reverse , the indicator on the
driver information display illuminates,
and the vehicle can now run normally.
If you fail to start the vehicle after 3
attempts, wait 3 minutes and try
again.
If you still fail to start the vehicle
after 2 rounds, stop trying to avoid
damaging your vehicle and contact a
smart Authorized Service Partner.
Powering off the vehicle
1. Make sure the vehicle is stopped.
2. Shift to park
.
3. The driver exits the vehicle from the
driver’s door with the key.
4. Lock the vehicle with the key and power
off the vehicle.
Under some operation modes, the
vehicle power cannot be switched
off by the operations above. The op-
eration mode needs to be turned off
prior.
Alternatively, the vehicle can be powered
off by tapping Power Off
on the
centre display when the vehicle is in park
.
The vehicle power will be switched
off after tapping Power Off. If a re-
start is needed, press the brake
pedal.
Functions of s-Pedal
With s-Pedal, it is possible to only use the
accelerator pedal to accelerate and brake.
Press the accelerator pedal for accelera-
tion, release the brake pedal and put your
foot on the pedal to make the vehicle de-
celerate slowly, and leave the accelerator
pedal to stop the vehicle completely.
When driving with s-Pedal enabled, an in-
dicator
illuminates on the driver in-
formation display.
When s-Pedal is disabled and the acceler-
ator pedal is not stepped on, the vehicle
will travel at a speed of 7 km/h(5 mph).
After s-Pedal is enabled, the vehicle will
coast to stop and Autohold will be auto-
matically activated.
Functions of s-Pedal
In case of any of the following circumstan-
ces, s-Pedal is not available:
● Gear position is in reverse
.
● Shifting to a wrong gear, such as shift-
ing to park
or neutral while
driving.
● Pressing the brake pedal to decelerate.
● Driving on a sloppy hill.
● Using Hill Descent Control.
● Using the parking assist.
● Using Adaptive Cruise Control.
● Using Highway Assist.
● Front Collision Mitigation is triggered.
● Automatic Parking Assist is activated.
● The drive mode is switched to the sport
mode or BRABUS mode.
Enabling/disabling s-Pedal
● Tap
> s-Pedal
to enable/disable s-
Pedal.
Driving and parking 99
To Next Page
Loading...
Need help?
General
