● Tap
> Lights > Environment
Light
> Approach Lighting
to turn on/off
the approach lighting (→ Page 150).
Automatic turning on/off of the lighting
The automatic headlamp function monitors
the ambient light intensity through the
sensor. When the light is dim, this function
can automatically turn on the low beam,
position lamps, rear plate indicator light.
When the light is sufficient, they are auto-
matically turned off.
Depending on the configuration, the sen-
sor location is different:
Type I
The rain light sensor is located on the
upper part of the front windshield, and the
automatic wipers/automatic headlamp/au-
tomatic climate control controls the corre-
sponding functions through this sensor.
Type II
The light sensor is located in the centre of
the instrument panel, and the automatic
wipers/automatic headlamp/automatic cli-
mate control controls the corresponding
functions through this sensor.
Automatic headlamp
Press the button to turn on the auto-
matic headlamp.
Automatic headlamp is only an aid. The
driver is responsible for adjusting the ve-
hicle's lighting based on road lighting, visi-
bility, statutory conditions and traffic
conditions.
NOTE
Never block the rain light sensor/light
sensor. Otherwise, the automatic head-
lamp/automatic climate control function
and automatic wiper function may not
work properly.
Headlamp leveling adjustment
Type I (for non-matrix headlamp)
Before driving, adjust the headlamp level-
ing according to the number of occupants
and luggage load.
Enter the setting interface:
● Tap
> Lights > Headlight height ad-
justment
> 3/2/1/0
to adjust the head-
lamp leveling.
Load Selection
Driver 0
Driver + front
passenger
0
All occupants
(driver + front pas-
senger + 3 rear
passengers)
1
Light and vision 75
To Next Page
Loading...
Need help?
General
