Emergency equipment
Using a safety vest
The safety vest is placed in the front pas-
senger side glove box.
1. To remove: open the glove box and
take out the safety vest bag
.
2. Open the bag
and take out the safety
vest.
Use the safety vest according to the label
on the vest.
The safety vest must be replaced in the
following cases:
● Reflective strips are damaged or dirty.
● The maximum number of washes is
exceeded.
● The fluorescence has faded.
Warning triangle
Taking out the warning triangle
1. Open the boot cover.
2. Take out the warning triangle .
Setting up the warning triangle
1. Fold the side reflector up to form a
triangle and snap on its top with the
upper clip
.
2. Spread the base
and lay it flat.
Place the warning triangle 50-100 meters
behind the vehicle on a conventional road.
Place it 150 meters behind the vehicle on
an expressway or more than 200 meters in
case of rain or fog.
Fire extinguisher fitting point
The vehicle is equipped with a fire extin-
guisher fitting point, consult a smart Au-
thorized Service Partner for details.
Fire extinguisher
If your vehicle is equipped with a fire ex-
tinguisher, it will help put out an initial fire.
Be sure to follow the operation manual
provided by the fire extinguisher
manufacturer.
NOTE
There are many factors that cause ve-
hicle fire. Usually, the fire can be extin-
guished in time by fire extinguishers in
the initial stage. However, if the fire is at
the development stage or fierce stage,
it can no longer be put out by fire extin-
guishers. In this case, it is necessary to
evacuate in time and call the fire
service.
If you need to install a fire extin-
guisher fixing bracket and fire extin-
guisher, consult a smart Authorized
Service Partner.
164 Breakdown assistance
To Next Page
Loading...
Need help?
General
