i-Size child restraint system
Front passenger seat Second row passenger seat
Passenger airbag
enabled
Passenger airbag
disabled
Second row out-
board seat
Second row middle
seat
i-UF i-U i-U X
i-UF: Suitable for a forward-facing i-Size child restraint system in the Universal
category.
i-U: Suitable for forward-facing and rearward-facing i-Size child restraint systems in
the Universal category.
X: Not suitable for i-Size child restraint systems in the Universal category.
aaa
Notes on installing a child restraint
system
WARNING Risk of injury due to sec-
ond row seat cushion and seat back-
rest not being engaged correctly
If the second row seat cushion and
backrest are not engaged correctly,
they may fold forward, for example,
when suddenly braking or encountering
an accident.
● In this case, the vehicle occupant will
be pushed into the seat belt by the
second row seat cushion or backrest.
Seat belts will not provide the best
level of protection and may cause ad-
ditional injuries.
● If the seat backrest is folded forward,
the objects or loads in the boot could
slip forward.
► Always make sure the second row
seat cushion and backrest are en-
gaged correctly before each journey.
When fitting a child restraint system, ob-
serve particularly the following:
● Always observe the correct use of the
seats and consider their suitability for
attaching a child restraint system.
● Always observe the child restraint sys-
tem manufacturer's installation
instructions.
● Make sure the child's feet do not touch
the front seat. If necessary, move the
front seat forward slightly.
● When installing a child restraint system
on the second row seats, adjust the
second row seats as far back as
possible.
When fitting an ISOFIX/i-Size child re-
straint system, also observe the following:
● When using a child restraint system in
weight category 0/0+ and the back-
ward-facing child restraint system in
weight category l on a second row seat,
adjust the front seat to prevent it from
touching the child restraint system.
● If necessary, remove the head restraint
from the corresponding seat when us-
ing a forward-facing child restraint sys-
tem in weight category I. In addition,
the backrest of the child restraint sys-
tem must be as close as possible to the
backrest of the vehicle seat.
After removing the child restraint sys-
tem, install the head restraint immedi-
ately and adjust it correctly.
Do not remove the head restraint when
using a toddler booster cushion.
● For certain child restraint systems in
weight categories II or III, the maximum
size setting may be restricted.
● The child restraint system must not
touch the roof and/or be fitted facing
the wrong direction.
42 Occupants safety
To Next Page
Loading...
Need help?
General
