is still abnormal, please contact a smart
Authorized Service Partner.
Factory Reset: tap Factory Reset to restore
the system to the factory default settings.
Energy management
Overview of the energy management
WARNING Risk of interference
caused by the centre display
You may be distracted if you operate
the integrated information and commu-
nication equipment while driving. You
could lose control of the vehicle.
► Note the road and traffic conditions,
stop the vehicle safely, and then op-
erate the centre display.
Enter the energy management interface:
● Swipe leftward from the right on the
centre display or tap
to enter the
application interface, and tap
to
enter the energy management
interface.
Function selection area:
● Charging
● Discharging
● This trip
● Trip
Function operation area
Charging and discharging
WARNING Risk of interference
caused by the centre display
You may be distracted if you operate
the integrated information and commu-
nication equipment while driving. You
could lose control of the vehicle.
► Note the road and traffic conditions,
stop the vehicle safely, and then op-
erate the centre display.
Enter the energy management interface:
● Swipe leftward from the right on the
centre display or tap
to enter the
application interface, and tap
to
enter the energy management
interface.
Charging
Daily Trip Mode: charge the power battery
to 90%, which is beneficial for the service
life of the power battery.
Long Trip Mode: charge the power battery
to 100%. This mode is recommended for
long-distance travel.
Charging reservation: tap "Schedule
Charging Time Setting" to enter the charg-
ing schedule interface. The user can set
the charging start and end time as needed,
and tap "Save". If the "Charging ends after
reaching target SOC" switch is turned on,
the charging process will not end when it
is the end time of the charging schedule
and the power battery is not charged to
the target SOC. In this case, the charging
process will continue to the target SOC be-
fore ending.
AC charging current: slide the touch bar to
set the current of AC charging.
Range: tap Standard and Dynamic to view
the range.
Discharging
Swipe on the dotted line on the car model
and select the target SOC when the Vehicle
to Load stops.
Discharge: tap Discharge to turn on the
discharging function.
154 Centre display
To Next Page
Loading...
Need help?
General
