Rear Cross Traffic Alert (RCTA)
When you are reversing out of your park-
ing space or garage, Rear Cross Traffic
Alert alerts you of the vehicle in the rear to
avoid collision if there is a risk of a side
collision. If necessary, brake will be applied
automatically.
If the vehicle is shifted to reverse
and
the vehicle speed is 0 - 18 km/h(0 - 12
mph), Rear Cross Traffic Alert will be
enabled.
If the system detects the risk of rear side
collision, the warning message will pop up
on the central display and the warning
mark on the outside rearview mirror will be
lit, with an acoustic alarm, to remind the
driver.
Limitations of Rear Cross Traffic Alert:
● Restricted driver assistance system
sensors may cause Rear Cross Traffic
Alert to work improperly.
● Never install accessories, such as dec-
als, in the rear angle radar surrounding
areas. Otherwise, the working range of
the sensors may be affected, thus caus-
ing some driver assistance systems to
fail.
● Severe weather conditions, such as
heavy snow, heavy rain, and fog, may
weaken the sensors or cause the sys-
tem to temporarily stop working.
● The rear angle radars may be interfered
by other radio devices or strong radar
reflections.
● In some cases, the rear angle radars
may take longer than expected to de-
tect other vehicles or completely fail to
detect them.
● When a vehicle is driving on the wind-
ing, narrow and steep roads or entering
or exiting a tunnel, the rear angle radars
may fail to detect rear vehicles or other
obstacles.
● Never slam into the sensor or the sur-
rounding area.
● The cracks/scratches or stone chips in
the rear bumper area behind the rear
angle radars affect the rear angle radar
function.
● To make sure the sensors work nor-
mally, the sensor area must be free from
dust, ice, snow, or other dirt, and the
area must be cleaned regularly.
● This function does not work on station-
ary or slow moving targets.
● The target is approaching too fast.
NOTE
Although the vehicle is equipped with
Front Cross Traffic Alert, always look
around and make sure the surrounding
is safe before reversing.
In the following cases when the rear angle
radars on both sides are blocked by the
surrounding vehicles and obstacles, Rear
Cross Traffic Alert is unable to detect the
oncoming vehicles in time.
Blind spot (sensor view blocked)
Detected area
Enabling/disabling Rear Cross Traffic Alert
Enter the setting interface:
● Tap
> Driving Assistance > Safe-
ty
> Rear Cross Traffic Alert
,
and set the Rear Cross Traffic Alert.
Driving and parking 131
To Next Page
Loading...
Need help?
General
