Replacing the rear wiper blade
WARNING Risk of being trapped if
the wipers are switched on while
wiper blades are being replaced
If the wipers begin to move while you
are replacing the wiper blades, you can
be trapped by the wiper.
► Make sure to switch off the wipers
before replacing the wiper blades.
Removing the wiper blade
1. Fold the wiper arm away from the
rear windscreen.
2. Remove the wiper blade
from the
wiper arm
along the direction of the
arrow
.
Installing the wiper blade
1. Place the wiper blade onto the
bracket of wiper arm
through the 2
lugs
.
2. Push the wiper blade
along the di-
rection of the arrow
until it is loaded
to the bracket
.
3. Make sure the wiper blade
is seated
properly.
4. Carefully fold the wiper arm back onto
the rear windscreen.
Rearview mirrors
Adjusting the outside rearview mirrors
WARNING Risk of injury if vehicle
settings are adjusted while the ve-
hicle is in motion
You could lose control of the vehicle
particularly in the following situations:
● If you adjust the driver's seat, steer-
ing wheel, head restraint or mirrors
while the vehicle is in motion.
● If you fasten your seat belt while the
vehicle is in motion.
► Before starting the vehicle, adjust
the driver's seat, head restraint,
steering wheel and mirrors and wear
the seat belt correctly.
Enter the vehicle setting interface, tap
Quick Controls > Exterior Mirrors
, and ad-
just the rearview mirror through the but-
tons on the right side of the steering
wheel.
When the seat memory is enabled and a
seat position is stored, the position of the
outside rearview mirrors is memorized
synchronously. When the seat memory
function is used next time, the outside
rearview mirrors will be automatically ad-
justed to the memorized position.
The memorized position will change
as personal accounts being
switched.
Automatic anti-dazzle of the outside
rearview mirrors
The outside rearview mirrors have auto-
matic anti-dazzle function. The lenses re-
duce the brightness of the light reflecting
82 Light and vision