Frozen washer fluid can prevent the
washer system from functioning due
to cold climate. If the washer fluid
lines are frozen, never use the wash-
er to avoid damage.
Rear wiper auto activation setting
Enter the setting interface:
● Tap
> Vehicle Settings > Vehicle
Control
> When reversing, rear wiper
turned off
to enable/disable the auto-
matic rear wiper when reversing (→
Page 152).
When this function is turned on, the rear
wiper will automatically works when the
vehicle is in
gear.
Front wiper maintenance mode
Turn off and set the front wiper to the
maintenance mode when replacing or re-
pairing front wiper.
Setting the front wiper to the mainte-
nance mode:
Enter the vehicle setting interface, tap
Ve-
hicle Condition
> Windshield Wiper Mainte-
nance
to enable/disable the front wiper
maintenance mode.
Before enabling the front wiper
maintenance mode, set the front
wiper switch to the OFF position.
Replacing the front wiper blades
WARNING Risk of being trapped if
the wipers are switched on while
wiper blades are being replaced
If the wipers begin to move while you
are replacing the wiper blades, you can
be trapped by the wiper.
► Make sure to switch off the wipers
before replacing the wiper blades.
Removing the wiper blades
1. Set the front wiper to the maintenance
mode (→ Page 81).
2. Fold the wiper arm away from the front
windscreen.
3. Hold the wiper arm with one hand, press
the clip inward along the direction of
the arrow
, and pull the blade out
along the direction of the arrow
with
the other hand.
Installing the wiper blades
1. Align a new wiper blade with the wiper
arm along the direction of the arrow
and slide the clip into the locked
position.
2. Make sure the wiper blade is seated
properly.
3. Carefully fold the wiper arm back onto
the front windscreen.
4. Start the vehicle.
5. Exit the front wiper maintenance mode
and the front wiper arms return to the
original positions.
Light and vision 81
To Next Page
Loading...
