MV-32/64 Multiviewer www.snellgroup.com Operation
Issue 1 Rev 11 Page 48 © 2014 Snell Limited
4.11.10.1 TSL Protocol Options
The TSL protocol options for TSL UMDs provide a number of ways of configuring the TSL
display address (see Table 25.).
TSL Protocol Option TSL Protocol Option Description
TSL UMD address 0 Assigns display address 0 to source 1 (video input 1), display
address 1 to source 2 (video input 2), etc.
MV-32 only
TSL UMD address 32
Assigns display address 32 to source 1 (video input 1), display
address 33 to source 2 (video input 2), etc.
TSL UMD address 64 Assigns display address 64 to source 1 (video input 1), display
address 65 to source 2 (video input 2), etc.
MV-32 only
TSL UMD address 96
Assigns display address 96 to source 1 (video input 1), display
address 97 to source 2 (video input 2), etc.
TSL UMD in source name Assigns each TSL display address based on the name of the
source set in the Sources tab (see section 4.11.3).
The source name must contain either “UMD” or “umd” followed by
a number indicating the display address.
Syntax Examples
For example to assign a source to TSL display address 14 any of
the following will work:
• Source 2 UMD14
• Source 2 umd14
•umd14
•UMD14
A source without UMD or umd followed by a number in its name
will not respond to any TSL display address.
Table 25. TSL Protocol Options
To Next Page
Loading...