Sonatest Wave - 13.4.5.1 Code and Calibration; 13.4.5.2 Gain and Amplitude; 13.4.5.3 Sizing Mode

Wave User Manual 85
Version 4
NOTE: Some parameters might be hidden when you look at the
screen. Do not hesitate to scroll with your finger.
13.4.5.1 Code and Calibration
This section is used to identify the procedure and calibration block used for the
inspection. By default, the fields are empty; they have to be entered manually.
13.4.5.2 Gain and Amplitude
This section presents the parameters Ref.Gain and Ref. Amplitude, which are related to
the source. Note that these parameters cannot be changed: they are read-only. This
avoids any errors that could have important repercussions on report quality.
13.4.5.3 Sizing Mode
This section presents the parameters related to the calibration. They are dynamically
displayed, depending on the calibration and the selected source. It is not possible to
modify them.
Table 30 shows the parameters according to the calibration selected
Table 30 – Calibration parameters displayed in the report
DAC
API
AWS
DGS
TCG
• Split DAC
• Transfer
Loss
• DAC
subcurves
• DAC trigger
• dr
• API K
• Transfer
Loss
• AWS A
• AWS B
• AWS C
• AWS C
Rounded
• Transfer Loss
• Near field
• Ref.
attenuation
• Mat.
Attenuation
• Ref. type
• Ref. size
• Ref. block
velocity
• Delta Vk
• ERS
• PED
• Gain mode
• DGS subcurves
• DGS trigger
• Transfer Loss
• Transfer
Loss
NOTE: If the selected source does not provide any calibration, this
section will not be displayed.