Specifications
Inputs/outputs
Serial digital input:
SDI IN connector (BNC type)
(up to 264 in steps of 33) 0.8 Vp-p
610%, 75 Ω
Channel coding:
Scrambled NRZI
Cable length
SD options:
200 m max. (With Belden 8281,
Fujikura 5C2V or equivalent coaxial
cable)
HD/SD options:
100 m max. (With Belden 1694A,
Fujikura 5CFB or equivalent coaxial
cable)
Input return loss
SD options:
15 dB or more (5 MHz to 360 MHz)
HD/SD options:
15 dB or more (5 MHz to 1.485 GHz)
Serial digital output:
SDI OUT connector (BNC type)
(Up to 272 in steps of 34)
Signal standard
SD options:
4:2:2 component serial digital signal
(SDI), conforming to
SMPTE259M-A/B/C/D
HD/SD options:
HD component serial digital signal
(HD SDI), conforming to SMPTE292M
Data transfer rate
SD options:
143 Mb/s to 360 Mb/s
HD/SD options:
143 Mb/s to 1.485 Gb/s
Re-clocking
SD options:
143, 177, 270, 360 Mb/s
HD/SD options:
143, 177, 270, 360, 540 Mb/s;
1.485/1.001, 1.485 Gb/s
Output return loss
SD options:
15 dB or more (5 MHz to 360 MHz)
HD/SD options:
15 dB or more (5 MHz to 1.485 GHz)
REMOTE 1
Connector:
BNC type (4)
Protocol:
Sony S-BUS
Data transfer rate:
312 kb/s (1250 kb/s will be
supported in the future)
Data transfer method:
Bi-phase Space
Cable length:
500 m max. (With Belden 8281,
Fujikura 5C2V or equivalent coaxial
cable)
REMOTE 2
Connector:
D-sub 9-pin (2), complies with
RS-422A signal standard
Protocol:
Sony Cart+
Data transfer rate:
38.4 kb/s
REMOTE 3
Connector:
D-sub 9-pin male (1), complies with
RS-232C signal standard, 38.4 Kb/s
DTR control, 8 bits, no parity, no
check, 1 stop bit
ALARM OUT:
Mini D-sub 9-pin female (4), Parallel
(relay contact outputs 6-ch)
REF IN:
BNC (4), with loop-through output,
tri-level sync or black burst signal
NETWORK:
RJ-45 (1), 100BASE-TX
General
Power requirements:
AC 100 V to 240 V, 50 to 60 Hz
Power consumption:
Approx. 900 W (fully loaded)
Operating temperature:
5 to 40 °C (41 to 104 °F)
Operational humidity:
10 to 90% (no condensation)
Dimensions (W x H x D)
440 x 974 x 520 mm
(17 3 /8 x 38 3 /8 x 20 1 /2 inches)
(Without projections)
Mass:
Approx. 90 kg (fully loaded) (198 lb)
Service parts: Extension Board EX-847 (Part No,
A-8329-772-A), Maintenance Manual Part II,
Protocol Manual
13
Routing Switchers
Routing Switchers
*SGC_0011-0038 02.3.16 4:59 PM Page 13
To Next Page
Loading...
