Applicable Models
BVS-A3232 Analog Audio Routing Switcher
BVS-V3232 Analog Video Routing Switcher
DVS-128 Routing Switcher
DVS-RS1616 RS-422A Remote Routing
Switcher
DVS-TC3232 Time Code Routing Switcher
HDS-X3400 Multi Bit-Rate Routing Switchers
HDS-X3600 Multi Bit-Rate Routing Switchers
HDS-X3700 Multi Bit-Rate Routing Switchers
HDS-X5800 Multi Bit-Rate Routing Switcher
Supplied Accessories
Operation and maintenance manual (1)
BNC T-bridge connector (1)
Specifications
Control signals
REMOTE 1:
S-BUS (BNC type) (1)
Data transfer method: BI-PHASE SPACE
Data transfer rate: 312.5 kb/s
Max. cable length 500 m
(when using Belden 8281, Fujikura
5C2V or equivalent 75 Ω coaxial cable).
Expandable to 1000 m with a
BKPF-L803 S-BUS Isolator/Expander
REMOTE 2:
D-sub 9-pin (1)
Data transfer method: Conforms to the
EIA RS-422A Cart+
Data transfer rate: 38.4 kb/s
RS-232C:
D-sub 9-pin male (1)
Data transfer method: 8-bit, no parity, 1
stop bit
Data transfer rate: 19.2 kb/s
General
Power requirements:
100 to 240 V AC, 50/60 Hz
Current consumption:
0.35 A
Operating temperature:
0 to 45 °C (32 to 113 °F)
Dimensions (W x H x D):
440 x 44 x 120 mm
(17 3/8 x 1 3/4 x 4 3/4 inches)
Mass:
Approx. 1.5 kg (3 lb 5 oz)
The BKS-R1617 multi-display control unit controls matrix
cross points in routers connected to an S-BUS system.
The BKS-R1617 also controls the monitoring output of
routers that have this facility. Source and destination
switching is performed with 16 buttons. The monitoring
signal can also be selected as a destination signal. The
shallow depth of the unit makes it easy to accommodate
the BKS-R1617 in front of a desk-mounted switcher
control panel.
Features
* Router control in S-BUS systems * Fully compliant with
expanded S-BUS systems * Source/destination selection
by scrolling through source and destination names using
the Selector knob * Four-digit display for each select
button * Button re-assignment using the Selector knob *
Improved monitor function for the selection of destinations
* Alternate source switching using Chop function *
Sources selectable to levels * Sources searched by
category * Access can be restricted to a defined block of
crosspoints * Large selector buttons show source and
destination name (Status shown by button color) * Several
crosspoints switchable with a single button (Phantom
function) * Route function for expanded sources * Number
of sources and destinations controlled expandable with
additional units * Control bridge between RS-422A (cart+
protocol) and S-BUS * Easy ROM update * Single cable
connection * Reduced depth helps in desk mounting
applications
BKS-R1617 Multi-Display Control Unit
Rear Panel
23
Routing Switchers
Routing Switchers
*SGC_0011-0038 02.3.16 4:59 PM Page 23
To Next Page
