MZC-88 Installation Instructions Page 11
7. TUNER 1 DISPLAY — LCD shows Tuner 1 status by: Zone, Band, Frequency, Preset, Mode and Frequency Lock.
8. PRESETS — Tuner 1 Presets 1-10. Press to select preset for programming or channel preset select by zone.
9. RDS BUTTON — Enables/disables Tuner 2 Radio Data System information. RDS displays station frequency, call letters,
broadcast genre and time.
10. MN/ST BUTTON — Toggles Tuner 2 FM stereo/mono modes. Mono can be useful for cleaning up background noise
on hard to tune channels.
11. AM/FM BUTTON —
Toggles Tuner 2 AM and FM bands.
12. ZONE BUTTON — Selects Tuner 2 Zone for programming and selecting Presets.
13. TUN +/- — Changes Tuner 2 frequency UP/DOWN when pressed.
14. TUNER 2 DISPLAY — LCD shows Tuner 2 status by: Zone, Band, Frequency, Preset, Mode and Frequency Lock.
15. PRESETS — Tuner 2 Presets 1-10. Press to select preset for programming or channel preset select by zone.
16. MASTER POWER SWITCH — When pressed to the in position, the MZC-88 is placed in the power ON standby con
-
dition, permitting individual zones to be turned ON and OFF by keypad, IR remote or touch panel commands. In the
OFF (out) position, power from the AC mains is completely turned off.
17. MASTER
POWER LED — Indicates when the Master Power switch is in the depressed position and that power has
been applied from the AC mains.
18. CONTROL PORT — One, 4 circuit 3.5mm mini jack connects to a PC running EZ-Tools for system programming and
Firmware upgrades.
19. FIRMWARE UPGRADE — One, two position switch enables the MZC-88 Control Port for Firmware Upgrades instead
of normal system program.
20. IR CAPTURE — IR learning eye used with EZ-Tools to learn IR Codes not found in the embedded IR Code Library.
21. ACTIVITY INDICATOR — Flashes when the system is learning IR commands or executing system functions.
To Next Page
Loading...
Need help?
General
