MZC-88 Installation Instructions Page 89
FIRMWARE & EZ-TOOLS UPGRADES
A major advantage of the EZ-Tools system is that operational improvements or changes can be implemented, in the field, at any
time. The latest versions of the Firmware for the MZC-88, LTM-1.0 Learn/Test Module, plus the EZ-Tools Application software, are
available on the SpeakerCraft web site, www.speakercraft.com. To install updates, proceed as follows:
FIRMWARE UPDATES
The first thing to do before the installation, configuration or programming of any SpeakerCraft control product, is download
the latest firmware for that product from the SpeakerCraft website. This will ensure that each product has the latest functionality
updates and fixes. To do so, proceed as follows:
1. Connect the “Transfer Cable” to the MZC-88 (or other SpeakerCraft product - refer to Figure 49).
2. To confirm the currently installed firmware version, left click “Tools” in the EZ-Tools Menu Bar and then “Get Product and
Firmware Version”. Refer to Figure 86.
Figure 86
Observing Current Firmware Version
3. To download the latest firmware, go to the SpeakerCraft web site at www.speakercraft.com. Left click “Downloads”,
then “Software”. Left click on “Firmware Updater (all models)”. When downloaded, the Updater will provide all cur-
rent SpeakerCraft Product firmware updates. Refer to
Figure 87.
Figure 87
Downloading Updates From the SpeakerCraft Web site
4. Click “Save” and select a hard drive location for the downloaded file. (The EZ-Tools Firmware Folder is a good place, so all
firmware files will be in one place.
5. After the download, double click the “Firmware Updater… .exe” file to launch the update and click “OK”. (If the “Open
File-Security Warning” Pop-up opens, left click “Run” and then “OK” on the Updater.) Refer to Figure 88.
6. A pop-up, “All files have been installed successfully” will appear. This means they have been placed in the “Firmware”
folder of the EZ-Tools directory. Click OK. Refer to Figure 89.
To Next Page
Loading...
Need help?
General
