MZC-88 Installation Instructions Page 65
EXPORTING SOURCE BANKS AS TEMPLATE FILES
1. Open the project from which Source programming will be exported. Click on the EZ-Pad icon in the desired zone (i.e.,
Zone 2) under Project Content.
2. Right click the desired Source button and click “Export Source to Template…” from the pop-up. (See Figure 53)
Figure 53
Exporting a Source To a Template
3. At this point, type a File name to identify that particular Source Template (i.e., “CD Player”) and click Save. This will add
the file to the Source Folder in the Templates subdirectory. (Refer to Figure 54)
Figure 54
Saving a Source Template File
4. Repeat this for each Source bank to be saved as a Source Template.
IMPORTING SOURCE BANK TEMPLATE FILES
1. Start a new project by creating a new project file name and assign the basic keypad configurations with SOURCE
SETUP and ZONE SETUP. (Open a New Project and setup the zones and keypads.)
2. Once the zone keypads are configured with the desired Source names, right click one (i.e., SAT) and click “Import
Source From Template…”. (See Figure 55)