Page 96 MZC-88 Installation Instructions
IMPORTING PRONTO HEX CODE
There may be times when special IR commands will be needed to perform certain functions, such as discrete power ON/OFF
codes, for AC Power management. The “
Remote Central” web site is a good source for such IR commands in Hex Code.
Once imported, EZ-Tools converts the Hex Code to IR commands, stores them in the Library and from that point, these codes
can be used on any projects subsequently programmed with EZ-Tools. To access and use these commands in EZ-Tools IR com-
mand lists, proceed as follows:
1. Under CMD Library, select the Brand, Model and Code Set of the component for which such commands will be added
(i.e., JVC, VCR, Code Set 2).
2. Right click the Code Set 2 folder, select New Commands in the drop down, then left click IR Commands. Refer to
Figure 101.
Figure 101
Accessing the New IR Commands Fields
3. The New IR Commands window appears. In the New Command Name field, type the name for the command to be
added (i.e., PWR ON (discrete).
4. Click the
>> arrows to place the new command name in the New Command List. Refer to Figure 102.
Figure 102
Adding New Command Names to a Command List
5. Repeat this for any other commands required (i.e., PWR OFF (discrete). When finished, click OK. The new command
names will appear at the end of the Code Set 2 Command List (in black print).
6. At this point, retrieve the Hex Code for these commands from Remote Central.
7. Via the Internet log on to the
Remote Central.com web site (www.remotecentral.com) and left click FILES.
To Next Page
Loading...
Need help?
General
