Page 54 MZC-88 Installation Instructions
Figure 39
Forcing Global Priority OFF
ZONE PRIORITY
To have full priority in any given zone (that is, to always be able to override other zone’s “First Come, First Served” selections
for all Sources within a Zone), proceed as follows:
1. Perform steps 1 through 5 in “Priority - First Come First Served”.
2. Right click the desired Zone (i.e. Zone 2 under Project Content) and left click “Force Zone Priority ON” and “Yes”
in the pop-ups. (Refer to
Figure 40) All function and numeric keys for all Sources in that Zone, where applicable, will
now have all their “Priority ON” options checked.
3. Repeat previous step for any other Zones that should have this action.
Figure 40
Forcing Zone Priority OFF
SOURCE PRIORITY
To have one or more single Sources have full priority in any given zone (that is, to have specific sources always override
another zone’s “First Come, First Served” selection for one or some, but not all Sources), proceed as follows:
1. In a specific Zone, right click the Source key that is to have Priority override (i.e. CD) and left click
“Force Source
Priority ON” and “Yes” in the pop-ups. (Refer to Figure 41) All programmed function and numeric keys for that
Source, in that zone, will now have all their “Priority ON” options checked.
2. Repeat the previous step for any other Source(s) in any other Zone(s) that should have this action.
Figure 41
Forcing Source Priority ON
To Next Page
Loading...
Need help?
General
