104
2019 Stenograph, L.L.C. All Rights Reserved.
104
Luminex Users Guide
Chapter 3 Writing on the Luminex
The roaming option is only used when all the access points you connect to have the same name
and passwords. For example, you work in an environment where you move from room to room
and you want the Luminex to automatically pick up the strongest signal.
·
To start or stop the sending of TrueStroke Data via WiFi to Case CATalyst, touch the Down or
Up sensor to highlight the Send TrueStroke Data via WiFi option and touch the Change sensor
to toggle between Yes or No.
·
To turn On an additional WiFi logging feature, touch the Down or Up sensor, if necessary,
to highlight the WiFi Log option and touch the Change sensor to toggle between Yes or No. The
default setting is Off. This option should only be turned On when you are advised by
Stenograph's Technical Support Department.
3. When finished, touch OK to save your changes and return to the WiFi screen.
To Next Page
Loading...
