39
2019 Stenograph, L.L.C. All Rights Reserved.
39
Luminex Users Guide
Chapter 3 Writing on the Luminex
If you are not using Case CATalyst, check with your CAT vendor to verify that your software
recognizes pause and resume commands, if not, do not use the Auto Pause Resume option.
·
Audio Format - allows you to set the audio compression format for recording. A higher
compression rate, ADPCM (14.7 MB/hour), produces a better audio quality and requires more
space on the Data SD card.
A lower compression rate, GSM (5.8 MB/hour), produces a slightly lower audio recording quality
and requires less space. Press the Change sensor to toggle your selection. Audio recorded to
the Backup SD card is recorded at the GSM format regardless of this option setting.
This option cannot be changed once you open a file.
3. To display the Opening or First Writing menu, press OK, More, Quit.
Audio Playback
The Play feature becomes available when you use a Search feature while writing a job. Play allows
you to playback the audio portion of the file from the point of the highlighted text forward in the file. The
Luminex highlights the corresponding steno and text on the tilting screen during the audio playback.
You can stop the playback at any time. A set of external speakers or headset is required for audio
playback.
To play audio while writing a job:
1. Using a Search feature, look for any of the following: Last Q, Last A, Last Mark, Steno or
Untranslate.
2. When you identify the position in the file from which you want to playback the audio, touch the Play
sensor or menu item. The Luminex begins the playback and simultaneously highlights the
corresponding text and steno.
3. Use the Quieter and Louder sensors to adjust the playback volume. If applicable, you may also
need to adjust the volume control on your headset or speakers.
4. Touch the Stop sensor or menu item when finished.
To Next Page
Loading...
