53
2019 Stenograph, L.L.C. All Rights Reserved.
53
Luminex Users Guide
Chapter 3 Writing on the Luminex
b. If using WiFi, click the radio button WiFi.
7. Click Export. The Luminex beeps and briefly displays a progress bar along with a series of
messages as the dictionaries load.
8. When the Luminex finishes loading the dictionaries, it reboots, displaying the Opening menu. A
verifying dictionary message may display. In CATalyst, depending on your Case CATalyst setting,
the message, Export Complete, may display.
Using Job Dictionaries
In addition to your main (personal) dictionary, you can use Case CATalyst exported job dictionaries for
translation when writing on the Luminex. You must load Case CATalyst job dictionaries onto the
Luminex in order to select them for translation.
When using the RTF2Writer program, you can load up to seven job dictionaries on the Luminex.
You can set job dictionary priority on the Luminex. When a stroke appears in more than one dictionary
with a different definition, the job dictionary with the highest priority is used to translate the stroke. All
selected job dictionaries have a higher priority than the main dictionary and the J-Defines in the
dictionary within the Luminex memory.
To set dictionary priorities:
1. From the Opening menu, touch Dict.
2. From the Dictionary menu, touch Select. The Job dictionaries display in the order they were loaded
onto the Luminex.
The following information displays for each dictionary:
·
Priority - the translation priority for the dictionary. One is the highest and ten is the lowest when
dictionaries are selected.
·
Job Dictionary Name - the file name of the job dictionary.
·
Date/Time - the date and time the job dictionary was loaded on the Luminex.
·
Size - the size of the job dictionary.
3. Select job dictionaries to use for translation and set the priority. Use the Down/ Up sensors to
move the pointer (>>) to the desired job dictionary and touch Select. The dictionary priority is set in
the order you select the dictionaries. To reorder the priority, touch Clear to deselect all the
dictionaries so that you can reselect the dictionaries in the desired priority order.
When the Case CATalyst Power Define dictionary is loaded, the Luminex automatically selects it
for use when making a J-Define. The Power Define dictionary takes priority over all other
dictionaries when creating a J-Define. It does not display in the dictionary list.
4. Do one of the following:
·
Touch Accept to save the selections. The Dictionary menu displays.
To Next Page
Loading...
