Stenograph LUMINEX - Beeper Volume; Function Keys (Touch Sensors) During Job

77
2019 Stenograph, L.L.C. All Rights Reserved.
77
Luminex Users Guide
Chapter 3 Writing on the Luminex
Beeper Volume
While you are writing, you may not be looking at the Luminex screen all the time. The Luminex has a
beeper to alert you to specific messages on the tilting screen, such as Low Battery. It may be
important to adjust the beeper volume depending your work environment.
To adjust the beeper volume:
1. From the Opening menu, touch Setup, More, Options.
2. Touch the Down/ Up sensors as necessary to highlight the Beeper Volume option.
3. Touch the Change sensor to toggle the Beeper volume between Soft and Loud. The Luminex
emits a softer or louder tone indicating the volume level selected.
4. To display the Opening menu, touch OK, More, Quit.
Function Keys (touch sensors) during job
The Function keys (touch sensors) during job option has three settings. On, Off and Only stenomark.
When the option is set to On, all the touch sensors are enabled while you are writing. This means you
can either use the touch sensors above the steno keys or the touch screen menu items to end the file,
insert a Mark, search for the last Q, etc. If this option is set to Off, the touch sensors are disabled
while in a job and you need to use the touch screen menu to navigate and to end a file. Setting this
option to No may be useful for those users who want to avoid the accidental touching of a touch
sensor while writing a job. Once you change to a different menu or end a job, the touch sensors are
available until you are in another job.
When this option is set to Only stenomark, the Mark touch sensors (insert a mark into the file) work
even if the rest of the function keys (touch sensors) are disabled. The touch sensors will work once
you are in an action. For example, let's say you touch More... on the touch screen and then touching
New View. All the touch sensors are available until you return to writing.
To select or deselect to use the function keys (touch sensors) during job option:
1. From the Opening menu, touch Setup, More, Options.
2. Touch the Down/ Up sensors as necessary to highlight the Function keys (touch sensors)
during job option.
3. Touch the Change sensor to toggle the options between:
· On. Selecting On means that all touch sensors are available while writing a job. (On is the
default setting.)
· Only StenoMark. Selecting Only stenomark means all the touch sensors except the Mark touch
sensors are disabled while writing a job. If you want a StenoMark in the file, you can touch the
Mark touch sensor or the touch screen. If you want to close the file, you need to press End on
the touch screen.