90
2019 Stenograph, L.L.C. All Rights Reserved.
90
Luminex Users Guide
Chapter 3 Writing on the Luminex
Steno Test
The Steno Test feature puts the Luminex in writing mode and simulates steno strokes for diagnostic
purposes. This feature is generally used at the request of a Stenograph Technical Support
Representative to test the Read and Writing features of the Luminex.
To activate Steno Test:
1. From the Opening menu, touch More, Diag, Steno Test.
2. Touching a menu action sensor or menu items such as Mark, Last Q or J-Define exits the Steno
Test mode but keeps the file open. To close the file, touch End.
If the option, Prompt to confirm ending job is active, a confirmation prompt displays, touch End to
close the job or continue writing to cancel the message.
To Next Page
Loading...
