46
2019 Stenograph, L.L.C. All Rights Reserved.
46
Luminex Users Guide
Chapter 3 Writing on the Luminex
Turn Brief It On or Off Before a Job:
1. From the Opening Menu, touch Setup, Trans. Opt.
2. Touch the Down/ Up sensors as necessary to highlight the Use Brief It option.
3. Touch the On/Off sensor to toggle the Brief It option On or Off.
4. To display the Opening menu, touch OK, More, Quit.
Turn Brief It Off During a Job:
Once a file is open, you can turn the Use Brief It option Off but you cannot turn it On. Once the option
is turned off while a file is open, you cannot turn it back on until you close the current job.
1. From the first Writing menu, touch More, Setup, Trans. Opt.
2. The cursor points to the Use Brief It option, touch the Off sensor.
If you touch OK without changing the option, the status of the option does not change.
Brief It Options
The following Brief It options are available in the Trans. Opt. screen.
To access the Brief It options:
1. From the Opening Menu, touch Setup, Trans. Opt.
2. Touch the Down/ Up sensors as necessary to highlight the Brief It options.
3. Touch the On/Off sensor to toggle the option On or Off.
4. To display the Opening menu, touch OK, More, Quit.
If the Use Brief It option is set to No, the other two Brief It options are not available.
Write Twice to Define
Brief It, by default, automatically creates a J-Define the first time you use a Suggested brief. When this
option is active, you must consecutively write a brief twice before Brief It creates a J-Define. All
subsequent uses of the brief only need to be written once. For example, Brief It suggests, P*F, for
“Piogenic Ventriculitis.” You want to use the brief so you write, P*F/P*F the first time, which places the
words “Piogenic Ventriculitis” in your transcript and puts the definition, P*F = Piogenic Ventriculitis, in
your job dictionary. To use the brief again, simply write P*F.
You may want to use this option to try a Suggested brief before making it a definition or to prevent a
possible misstroke in accepting a brief. The default is Yes.
Only Suggest One Stroke Briefs
To Next Page
Loading...
