50
2019 Stenograph, L.L.C. All Rights Reserved.
50
Luminex Users Guide
Chapter 3 Writing on the Luminex
is no longer recorded to the Data SD card. If you start a job and there is 75MB or less available on the
Data SD card, audio is not recorded to the Data SD card.
Once a Data SD card is full, steno, timestamps and audio are no longer saved to the Data SD card
but continue to be saved to the Backup SD card. Steno and timestamps also continue to be saved to
memory.
You can change the Data SD card any time during the writing process by first closing the open file
and turning Off the Luminex. When you insert a new Data SD card and turn the Luminex On, a new
file is created as you begin writing. Files cannot span Data SD cards. You can merge the files
together later on your CAT system.
Check the Data SD Card Space
1. From the Opening menu, touch Storage, SD Card, Information.
2. To display the Opening menu, touch OK, Quit, OK.
Change the Data SD Card
You should always carry an extra Data SD card with you. In the event that your Data SD card
becomes full, you most likely will want to remove the full card and insert a new card. You need to turn
Off Luminex before removing the Data SD card.
To change the Data SD card while writing:
1. On the First Writing menu, touch End to close the open file.
If the option, Prompt to confirm ending job is active, the following confirmation prompt displays: To
Confirm End of Job, press End. Touch End to close the job or continue writing to cancel the
message.
2. Turn the Luminex Off and remove the current Data SD card from the Data SD card slot.
The message, Disk in use -- Put it Back! displays when you attempt to remove the Data SD card
without closing the file by touching End; or you attempt to remove the Data SD card before the
Luminex has finished writing information to it.
3. Gently insert a new formatted Data SD card until you hear a soft click. If the card does not easily
insert, do not force it. Remove the card and reinsert it, ensuring it is straight without angling.
4. Turn the Luminex On and continue writing.
View and Copy Data SD Card Files
The Luminex names job files using a year, month, date and time format. For example: 20190122-
142341 (January 22, 2019 2:23:41 p.m.) Job files are stored in folders identified by year and month.
For example, 201901. By default, the newest file is listed first.
To Next Page
Loading...
