Stenograph LUMINEX

To Next Page

To Previous Page

Luminex Users Guide

Chapter 3 Writing on the Luminex

b) Split/Stack Adjustment - When you experience splitting steno outlines or multiple steno

outlines becoming one, adjust the Split/Stack Adjustment setting. It is strongly recommended

that you select the first available setting and assess the change. Turn on CNN or the equivalent

and write against the broadcast for 20 - 30 minutes.

The default setting is Balanced. Use the + and - sensors to select one of the following:

Less Splitting 1 - Multiple steno outlines show in your steno notes that are intended to be one

stroke.

Less Stacking 1 - Single steno outlines show in your steno notes that are intended to be two

strokes.

c) Transition Time - Transition time is the number of milliseconds that pass between the release

of a key stroke and when the Luminex recognizes the next key stroke. This can affect the

stacking or splitting of steno outlines. If you experience stacking or splitting steno

outlines, adjust the

Split/Stack Adjustment option first. If the Split/Stack Adjustment settings do not resolve the

splitting or stacking of steno outlines, set the Split/Stack Adjustment option to “Balanced”

before changing the Transition Time setting. It is strongly recommended that you adjust the

transition time in a small increment and assess the change. Turn on CNN or the equivalent and

write against the broadcast for 20 - 30 minutes.

The default setting is 8 milliseconds. Use the + and - sensors to choose a number between 2

and 66.

Lengthen transition time setting - If split steno outlines continue to show in your steno notes,

lengthening the transition time should help. Split steno outlines indicate that the transition

time is too short. Increase the transition time setting in small increments. To increase the

transition time (lengthen the time allowed for strokes to be combined into one) touch +

(plus). For example, if the Transition Time setting is 8 ms (default), touching + increases the

transition time to 10 ms.

Shorten the transition time setting - if stacked steno outlines continue to show in your steno

notes, shortening the transition time should help. Stacked steno outlines indicates that the

transition time is too long. Decrease the transition time setting in small increments. To

decrease the transition time (shorten the time allowed for strokes to be combined into one),

touch - (minus). For example, if the Transition Time setting is 8 ms (default), touching -

decreases the transition time to 6 ms.

d) Return to Factory Default Settings - Reset all the keyboard options to the default factory

settings. Use the - (No) or + (Yes) sensor to make your selection. If you only made changes in

Adjust Keys feature, you will not prompted to save the settings as indicated in the next step.

1. Touch OK. You are prompted to save the settings to a Keyboard profile. If you made these

adjustments while writing, after you end the job you are prompted to save the settings to a profile.

Stenograph LUMINEX - Page 76